Zenki 6.7 with a Weir spool, new bearings, ANSWER solid pinion spacer.
Mr track car!
Moderators: BOBLOOK, AE25, pufito18
Re: Mr track car!
Some normal RWD valve covers, after walnut blasting. Drilled out the rivets to the upper chamber/PCV outlet.
Look how clogged and shitty the little vent holes are...
After drilling this by hand I wish I had done it on the mill. So many ribs below.
-8 bung installed.
New little baffle installed.
Other side. required a little cutting to make space.
Ready to get cleaned and painted!
Look how clogged and shitty the little vent holes are...
After drilling this by hand I wish I had done it on the mill. So many ribs below.
-8 bung installed.
New little baffle installed.
Other side. required a little cutting to make space.
Ready to get cleaned and painted!
BCWorks
Re: Mr track car!
New engine mounts to move the motor back 40mm
[imghttp://25.media.tumblr.com/d2fb7f17615212da3ebf1360604fa56f/tumblr_mkgek2OcIv1rqnromo3_1280.jpg][/img]
I also had to make a low profile water neck for the back of the head.
[imghttp://25.media.tumblr.com/d2fb7f17615212da3ebf1360604fa56f/tumblr_mkgek2OcIv1rqnromo3_1280.jpg][/img]
I also had to make a low profile water neck for the back of the head.
BCWorks
Re: Mr track car!
Looks awesome. Post some vids if you got them I like the ride height. Where did you get the headlight covers?
Re: Mr track car!
They are Volkswagen, and after a week I started to hate them and took them off. You want? Haha
I will when I get back home after this weekend. I'm at DUI13
I will when I get back home after this weekend. I'm at DUI13
BCWorks