tranny expert question for T50
Moderators: BOBLOOK, AE25, pufito18
tranny expert question for T50
I have a T50 from an 81-82, I swapped the Tail shaft off an early T50 to move the shifter forward,
I got the transmission in the trunk of the car so I don't know if it was working correctly , Nothing seemed wrong when I opened it up... no metal shavings or grinded teeth.....
I installed it and now its grinding real bad to go into Reverse. But if I throw 3/4 then Reverse it goes
in fine. Anyone know what is going on?
I got the transmission in the trunk of the car so I don't know if it was working correctly , Nothing seemed wrong when I opened it up... no metal shavings or grinded teeth.....
I installed it and now its grinding real bad to go into Reverse. But if I throw 3/4 then Reverse it goes
in fine. Anyone know what is going on?
Re: tranny expert question for T50
yeah.... why?
Re: tranny expert question for T50
Maybe differance in the lever
Is youre clutch releasing properly no air in the clutch cylinder ?? bleed or adjust !
Is youre clutch releasing properly no air in the clutch cylinder ?? bleed or adjust !
The day we learn to think
Re: tranny expert question for T50
Well the shift rods where changed over also. Everything was a direct swap. Converting it to a Early style
T50.
Someone else told me to check the clutch to make sure its engaging correct. Everything is pretty much new...Clutch/Plate/Bearing/Slave Cylinder..... I got under the car while someone step on the pedal and the slave came all the way out... I took the boot off the fork and saw the plates springs get flat.....
T50.
Someone else told me to check the clutch to make sure its engaging correct. Everything is pretty much new...Clutch/Plate/Bearing/Slave Cylinder..... I got under the car while someone step on the pedal and the slave came all the way out... I took the boot off the fork and saw the plates springs get flat.....
Re: tranny expert question for T50
can you move the fork by hand ? before the release bearing touch the pressure plate ? how much plaiy to it has !
The day we learn to think
Re: tranny expert question for T50
I don't think it had any play in it...Do I remove the Slave Cylinder and check the play?