tranny expert question for T50
Moderators: BOBLOOK, AE25, pufito18
Re: tranny expert question for T50
Using the 1st one to the left in the pic. Bell housing is for the Big starter.
Re: tranny expert question for T50
Not so sure its just a clutch issue.. some Qs
Did forkshafts slide smoothly ? could they have been bent ? stick?
What oil are you using ? Is it just when its Cold or warm also ? have you driven it for a while ?
Did forkshafts slide smoothly ? could they have been bent ? stick?
What oil are you using ? Is it just when its Cold or warm also ? have you driven it for a while ?
Re: tranny expert question for T50
tojo:
The Fork/shift rods Where not bent, but they where a little ruff...they came out of a Transmission that was water locked. I cleaned them up as much as I could....
Using Synthetic 85/140 I think....
Car has not been Driven, It just got put back together
The Fork/shift rods Where not bent, but they where a little ruff...they came out of a Transmission that was water locked. I cleaned them up as much as I could....
Using Synthetic 85/140 I think....
Car has not been Driven, It just got put back together
Re: tranny expert question for T50
Id use a synthetic GL4 oil 75w-90 drive it and see if shifts improve. Mine did. Was a bit cranky when cold at first
but fine after about 1000km . Not as smooth to get in reverse as the newer style due to the "lift for R" but shifts fine now
but fine after about 1000km . Not as smooth to get in reverse as the newer style due to the "lift for R" but shifts fine now
Re: tranny expert question for T50
Ok ill try it....i just got the exhaust done so ill be able to go around block
Re: tranny expert question for T50
Even tho I replied to the thread title I`m no expert or pro on the subject
Just going on opinion and a bit of experience
Good Luck
Just going on opinion and a bit of experience
Good Luck